Drill Master 500X Manuale Utente Scaricare il pdf (Pagina 5)

3

Installation

(continued)

Electrical Installation

This section explains how to connect your

DrillMaster to a 12-volt power source.

NOTE: The DrillMaster must be connected

to a 12 volt DC negative ground

electrical system.

POWER/BATTERY CONNECTION

Locate the power cable for the DrillMaster and

route to the battery. When routing cable to

console, avoid areas where the cable may be

subjected to abrasion or excessive heat. Attach

the BLUE wire (ground) to a screw or bolt on the

equipment frame. See illustration 3. Be sure

there is a good metal-to-metal contact. Connect

the ORANGE wire to the positive battery

terminal. Connect the power to the DrillMaster

console by plugging the 2-pin W/P tower on the

power cable into the 2-pin W/P shroud of the

display console.

ON/OFF SWITCH CONNECTION

The DrillMaster system uses P/N 14360 power

switch to turn the system on. If the P/N 14360

power switch is used, simply mount the switch

bracket as shown on page 4, and plug the

connector into the mating cable from the

console.

Attaching the Speed Sensor

The DrillMaster uses an Astro 5 GPS Speed

Sensor. The speed sensor always connects to

the 3-pin M/P connector with the yellow tie (on

the back of DrillMaster).

Speed calibration entered into the controller

must be 0.189.

1 2 3 4 5 6 7 8 9 10 ... 19 20

Commenti su questo manuale

Nessun commento