Drill Master 500X Manuale Utente Scaricare il pdf (Pagina 4)

Installation

Mounting the Display Console

Select a mounting location which seems most

workable, and that best fits your needs. It

should be convenient to reach and highly visible

to the operator. DO NOT INSTALL IN A

POSITION THAT OBSTRUCTS THE VIEW OF

THE ROAD OR WORK AREA. Whenever

possible, avoid locations that expose the

console to direct sunlight, high temperature,

strong chemicals or rain. Place the mounting

bracket in selected location, mark hole, drill ¼”

(7mm) holes and mount bracket with bolts,

lockwashers and nuts provided. (Use self-

tapping screws if not practical to use bolts.) See

Illustration 1A. Put rubber washers on carriage

bolts and put the bolts through the bracket holes

from the inside out. Loosely attach the mount

knobs onto the bolts. Place console over

carriage bolt heads and tighten knobs to secure

the console. See Illustration 1B.

Attaching the Power and Run/Hold Control Switches

Mounting the Run/Hold Switch Kit

Remove the mount knob from either side of the

console. Install the bracket over the carriage

bolt and along side the console bracket. Install

the mount knob on the carriage bolt and tighten

to secure the console and run/hold switch

bracket in place.

Install the switch into the bracket using the steps

below:

1. Place the small washer on the switch

followed by the flat “notched” washer. See

Illustration 2.

2. Secure the washers in place with one of the

hex nuts.

3. Peel the back from the decal and secure to

the front of the switch bracket. See

Illustration 2.

4. Install the switch in the bracket and secure in

place with the remaining hex nut.

NOTE: Make sure the “ON connector is at

the top.

5. Attach the quick disconnects on the switch

harness to the switch. The RED wire should

attach to the top connection with the BLACK

attaching to the bottom connection.

6. Install the switch harness connector into the

mating connector (gray tie) on the console

harness.

NOTE: If using the included Power

On/Off switch instead of the

ignition switch connection, install

the power switch as described

above. Connect the power switch

cable connector (2 pin) to the

mating connector on the console

harness.

1 2 3 4 5 6 7 8 9 ... 19 20

Commenti su questo manuale

Nessun commento

Drill Master 500X Manuale Utente Pagina 4

Commenti su questo manuale

Prodotti e manuali riguardandi Attrezzi elettronici Drill Master 500X